Picture of Striping Teflon Wire



Use a brand new utility razor blade. Picture shows the covering pulled off the shield after cutting lengthwise on the insulation.

Pull down the shield, then using a very small screwdriver, make a hole a the bottom of the shield, pull the center conductor out of the shield.

Again, using a very sharp utility razor blade, cut the insulation on the center wire lengthwise, and pull the wire out. Be carefull, it is easy to cut the wire also. You can barely see the insulation off to the side of the exposed wire.

Finally, cut off the unused insulation.

Back to Blue Lightning Transceiver - Section 3, VFO OUT to VFO IN Coax Cable

Send E-Mail || Amateur Radio Receivers || Electroluminescent Receiver || Back to Jumpers & Controls

Last Update: 10/2/04
Web Author: David White, WN5Y Free Website Translator