|
The following is the shorter board, now being shipped with the kit. The Frequency Counter can be mounted up front as shown in other pictures, with the Stabilizer behind it. The back two spacers are installed but sit on the table. If needed two screws and a small washer or two can be installed on the bottom of those spacers to level the receiver. The three spacers on the left are underneath the VFO and help in stabilization. |
|
With the spacers now being shipped with the kit, a male end will be at the top. Spacers are very difficult to find, and the way they will be used will change depending on what can be found. This picture is just to show where they go on the bottom board. |
|
|
|
|
Send E-Mail || Amateur Radio Receivers || Electroluminescent Receiver
